Barrel Threading Service for Attachments (Supressor, Muzzle Break, Flash Hider Etc.)

 
 
 

 
 

IMPORTANT: DO NOT send a firearm.  This is a Lower receiver for AR's (uppers OK), A lower receiver for S&W M&P 15-22 etc.  If you are not sure - Ask.  Only send barrels (or barrels mounted to upper receivers (AR, M&P etc) if you want me to remove and re-install the barrel for threading.) Remove Ruger 10-22 barrels from receiver before sending.

Some other barrels can be threaded - ask before sending (I.E. Uzi, Browning auto take-down, Marlin Papoose).

Return shipping: $15 flat-rate per barrel

How to send your barrel:
  • Package it with a return address inside the package
  • include a note stating sight or no sight for Ruger (see above)
  • A money order or bank check for threading fee plus return shipping fee (I.E. $105 = $90 +$15 return shipping)
  • Tape on barrel with arrow indicating desired finished barrel length if barrel is to be cut (no shorter than legal)
  • Thread pitch desired - (1/2 x 28 TPI standard for .22/.223)
    • Available: 9/16 x 24 RH & LH, 5/8 x 24 RH, 14 x 1mm LH Metric
    • others by request - ask before you send your barrel
Ship Barrel To:
Mark Mauzy, LLC
755 S 400 W
Provo, UT 84601

Note: INSURE your barrel when you send it - I cannot be responsible for what I don't receive.
Thread protectors not included at this time.


Contact: Send an email to Mark with any Q's